Starting in the top left and going down and counter clockwise.

1. Broom clip used to apply tension to the front seat leg to hold it in position. (Failed - No Longer Used)

2. qty 2 - 1/2 inch copper tubing caps. Used to close off the end of the front leg

3. qty 2 - 1/2 by 1 inch long pieces of rigid copper pipe to connect the caps to the street elbows.

4. qty 2 - 1/2 'street' elbows, installed in the ends of the conduit and form part of the 'hinge' for the front leg.

5. qty 2 - 3/4 inch plastic conduit clamps, these hold the copper elbows to the seat bottom and are the other half of the hinge

6. Qty 2 - 1/4 inch shelf support brackets, these are the rear seat supports and pivots. (Failed - No Longer Used)

7. Qty 1 pair - 2 inch wide 'narrow' brass hinges, these attach the seat back to the seat bottom

8. Qty 1 - 1/2 emt conduit bent in a 'U' shape that is 15 inch from outside to outside and the legs are 10 inches from the floor to their tops.