Submitted by user Kevinfr

Complete restoration of a 1975 Larson Commander 21

Submitted by user p12

Planning/hoping/anticipating restoration/revision of "Inviscid", a 1986 Sylvan V171 stern drive bow rider, w/a Mercruiser Alpha One 140hp/3.0L. Inviscid was purchased new by my father and used until 1998, i retrieved her in January of 2004. Since then, the Mrs. and I purchased another boat to play with, so now i can get back to work on Inviscid. In her current/initial state, the engine will run barely, I was quoted $900 for a complete rebuild (including another block that will be bored 30 over) from a reputable shop in the area. The entire interior needs redone and i know of a soft spot on the floor , port side next to engine. Hopefully, the current excitment will continue til the floor is strong and the engine is done, then the excitment of running her will be motivation enough to complete her.

Submitted by user ericbaikie

I bought an old 16' Aroliner Aluminum off some old guy in the boonies and am fixing it up a little. I have a pretty low budget though because I'm still in school and haven't found a summer job yet, but I'm good with a wrench and am friends with the owner of the local marince recycler.

Submitted by user Saxis

This is my 14 ' 1958 Fleetform with 1967 Evinrude Lark VII 40 HP restoration. Boat and trailer were purchased for $200, both need LOTS of work. I used the boat a few times to catch the opener of last trout season, but it has been sitting all summer. The outboard (not pictured) was purchased on Ebay for $350 and is in rather good condition despite sitting in the Seattle rain for 3 years.

Submitted by user Ralphw

Major restoration of Nice old Grady White Hatteras 17.5' lapstrake runabout. Just want to mention Mike and thank him for everything. Well finally got it in the water and it rides as good as it looks august 1st 2006