Useful Links
Tilt/Trim
Have to hold the motor
You have to hold up the motor to remove the two big bolts for the til/trim unit.
Notice the 5 bolts?
To of the bolts are missing and 1 is actually broken
Trim cylinder
Needed repair.
The trim cylinder is not straight
Notice the line on the trin cylinder? It should be straight with the base. As the bolts are missing its a wonder it worked at all.
These were the olny bolts left
1 of these is broken be remanded in the hole. 1 is actaully bent the other is Ok but was very loose. The spec call for 95 inch pounds to all 5 bolts.
Tilt Cylinder
The tilt cylinder should have has the 2 O rings replaced. I could not find or buy a spanner wrench that fit. I needed the smaller pined adjustabe type and got the bigger 1. If the tilt goes out I will fix it then. Same with the pump and motor.
Trim removed
I got fed up with the tim failing and takeing the tilt away also. I was informed to plug the trim hole in the pump and just use the tilt. So far works fine.
My old prop and new
(Insert New Description)
old prop blade
(Insert New Description)
New prop blade
(Insert New Description)
(Insert New Caption)
(Insert New Description)
(Insert New Caption)
(Insert New Description)
(Insert New Caption)
(Insert New Description)